As early as in ancient times, humans have been know to use leather to improve their lives and make them more books are; Today, people could not find a better alternative, only natural leather could be so beautiful, lively and diverse.

Because the leather is derived from animal products, every animal, every piece of fur is unique, with the appearance of different characteristics. When furniture of choose and buy, many consumers tend to some natural on the leather surface class mark as a major flaws, cause unnecessary misunderstanding and dispute between the seller and the buyer, to buy a leather furniture, and often do not know how to properly maintain that reduce the service life and the mistake to buy bad products; This article will introduce some common characteristics of leather and maintenance of common sense for readers reference.

The general principles of the leather maintains

Leather is easy to take care of, but some necessary maintenance is negligence shall not, leather is very sensitive to certain conditions. Never use a stain remover, solvents, turpentine, shoe polish, or strong detergents to clean the leather furniture.

Use professional designated maintenance agent for daily maintenance.

Limited use of leather fragrances or polish.

Do not often send factory for dry cleaning or finishing.

Benzene, coupled with a layer of protective film after dyeing of leather, with leather grain natural aesthetic feeling and the advantages of good finishing, very soft and colour and lustre is bright beautiful. Daily care of wipe the dust off and use for leather cleaner, avoid friction. Dust with a soft cloth to wipe clean method. Coagulation dirt using professional leather cleaner. Liquid with strong absorption of towel blot, immediately and avoid to wipe the same parts. After food and grease, immediately remove pollutants according to remove dirt of solidification processing method.

Suede or skull patch (Rawhide

Through special processing some fluff feeling the surface of the leather, some use the back of the leather manufacturing (skull patch). Using benzene dye to keep the leather soft characteristics. Avoid glare or the influence of the sun. Use vacuum cleaner regularly. Brush with rubber, fine sand paper or sponge surface finishing to maintain hair natural feeling. Use a vacuum cleaner to remove. Off again with a vacuum cleaner to remove with a brush. Ring with wet napkin or dry towel to wipe, if necessary, can be used wet dishcloth touchs take neutral detergent to wipe, remember that control the dishcloth of water not too much; After being leather dry thoroughly, the appearance of the surface of the back with the brush. Immediately remove the pollutants. With neutral cleaning essence or household cleaners in wet cloth to wipe, control the moisture of cloth; It completely dry carefully restored with the brush appearance. On the surface of the residual traces will gradually absorbed by the leather.